Operation method of ice maker
2, the adjustment of ice bridge thicknessThe ice bridge thickness is about 3mm, and the inter probe evaporator should be higher than the actual thickness of the ice bridge 1.5mm, clockwise rotation of the adjusting screw and increase the thickness of the ice bridge (screw rotating ring 1/3 ice bridge thickness 1.5mm).The connection check ice plate probe and a connection bracket, should guarantee the free rotation of each ice making process can return to the correct position.
When the ice thickness reaches the set when the thickness of the ice plate probe started, a defrosting electromagnetic valve to work, the water pump stops working, the hot air into the evaporator, about 1 minutes of ice. When the ice falls, turn the ice down plate and turn on the reed switch. When the reed switch is closed, the machine enters another ice making process.Don't stop the compressor in the ice and Ice Shedding process.When the ice bucket with ice storage, magnetic reed switch can not be automatically closed when the machine stops working automatically, when removed enough ice, the magnetic reed switch is closed again after a delay of 3 minutes after the machine start, re entered the ice making process.
Ice making processIt must be checked before starting the automatic water supply device is normal, the level of water storage tank is reasonable (the factory has just adjusted level, users can not be adjusted).The plug, the ice machine starts to work, the first pump starts running (exhaust air pump for a short time) about 2 minutes after the compressor is started, the machine enters the state of ice.
