Ordinary lathe, a little card in the pallets
Adjust the side also need to shake back and forth in the palm of the hand side of the adjustment, while observing the dial, the hands feel "neutral" for 3 to 4 small grid is appropriate.
Figure, screw nut adjustment screw is used to adjust the screw gap, if transferred too tight will make the tray "card".
Elastic (at this time shake the handle of the hand will feel), and finally tighten the rear adjustment screw, OK;
The plug is used to adjust the guide clearance, which has adjustment screw (before and after each one), first relax the rear adjustment screw, swing back and forth in the pallet handle, so that the carriage before and after the move, while turning the screw with a screwdriver to adjust the appropriate
