Outdoor fitness equipment should be set aside around the distance
The site and surroundings of the outdoor fitness equipment shall comply with the following requirements:1, outdoor fitness equipment from overhead, high voltage wire level should be no less than 3 m;2, outdoor fitness equipment from the underground pipe, the edge of the ground line level should be no less than 2 m, from all types of office buildings, residential buildings and all types of buildings, the horizontal distance between the tube house should be no less than 5 m;3. Where the equipment is needed for the night, the illuminance shall be no less than 15 LX within the range of 2 m of the equipment edge;4, outdoor fitness equipment should be away from flammable, explosive and toxic and harmful substances, site fitness should comply with the relevant provisions of the national security.
From the outer edge of the range of 0.5 M equipment foundation ground should be hardened, such as hardening of concrete, compacted soil after brick paving; surface hardening equipment foundation and surrounding the installation of equipment shall not be higher than the surrounding ground.The horizontal bar, parallel bars, ladder and swings up and down movement or bounce may fall from the air moving equipment, the movement of the ground should be soft or elastic buffer surface, such as sand layer, rubber floor etc.. If the rubber floor structure, the thickness of the floor should be not less than 25 mm; if the sand, sand layer thickness should not be less than 200 mm, and the bunker due to the surrounding the appropriate height of the convex envelope, convex edges and corners should be set to a radius of not less than 10 mm in the corner.
The ground installation of the equipment and its buried underground structure shall comply with the following requirements (except for the larger ground frame type equipment):1, buried equipment column should be firmly fixed to the lateral support or support plate;2, installation of equipment should be soil, geological structure for fastening coefficient is not less than 0.7 of the class II general hard soil and above non osteoporotic and non sandy loam class within 800 mm depth from the surface; otherwise, the equivalent soil treatment, can install equipment;Note: Class II hard soil with a fastening factor of not less than 0.7 may be dug with a shovel and determined by the degree of difficulty of the excavation. The soil that needs to be dug with a shovel and excavated with a small number of picks can be regarded as a class II hard soil with a fastening factor of not less than 0.7The 3 column, equipment buried depth: when the equipment above ground height of 2000 mm, shall not be less than 500 mm; equipment above ground height of 1000 mm and 2000 mm, shall not be less than 400 mm; equipment above ground height of 1000 mm, shall not be less than 300 mm; the concrete bearing layer at the bottom of column equipment the following should be not less than the thickness of 100mm;
