ty-la10 projection lamp replacement, counter reset method?
3. for a good projection lamp, projection lamp timer for the following reset method: switch on the power, turn on the TV, press and hold the power on state television at the same time, the volume on the "-" MULTI PIP button on the remote control and more than 5 seconds.
Note 1. the projection lamp is very hot. When the power is turned off, unplug the power plug and replace it after 1 hours2. the TV set has a forced cooling function. After turning off the power, press the volume on the TV, "+" and the remote control channel "+" button for more than 5 seconds at the first minute of normal cooling. The cooling fan will continue for about 10 minutes.
Change method 1. press the power button on the remote control to turn off the TV2. wait about 1 minutes until the cooling fan stops running and shuts down properly3. unplug the power plug and wait for 1 hours until the projection lamp is fully cooled4. remove the front panel unit and projection lamp cover, replace the projection lamp 5., install the projection lamp cover and front cover panel unit
