Such as title, please have welding patch LED lamp experience expert guidance, do not search from the Internet to the theoretical knowledge, thank you!
Recommend to communicate with older employees, they will have a lot of welding experience
If the power of the lamp, because heat high power do very well, so not good welding, the temperature at the highest (300 degrees), the use of horseshoe iron head, not waiting to solder, because the heat is very powerful, quick action.
First of all, welding LED and other electronic products with line electrostatic ring, to prevent static light.When welding the patch LED lamp, first add the tin on the pad of the lamp board, then clamp the LED patch lamp with tweezers. Then, the soldering iron will melt the tin of the solder plate of your lamp board, and then push the LED lamp onto the pad with tweezers. The whole welding process should not exceed 5 seconds, otherwise it will burn the lamp easily.
The welding speed and welding time because certainly give light foot heat, so the speed must be fast, tin wire and tip with better, while heating to tin iron head, avoid heating time is too long.
When soldering, the temperature is best to be lower, and the average welding temperature is about 360. That's enough, because the melting temperature of the tin wire is about 220 degrees, so if it is allowed, the temperature can be reduced as low as possible.
