Please tell me how to adjust the thickness of edge banding. Also help to explain the R knife, profiling wheel, taper wheel, and the side pressure wheel. Thank you very much
Not far from the glue pot, there is a digital mechanical manual adjustment handle. It can be adjusted to 1-4 mm thickness according to the thickness of edge banding. Be careful。 Now buy the edge of the market are not thick enough,.1 mm, are 0.8 or 0.9. Turn it down, please
Hello, first of all thank you for your trust in me. According to your question, I simply said I understand the edge banding machine knowledge, incorrect place, please forgive me. You are using automatic linear edge banding machine is right, edgeband thickness regulating tape feed mechanism need (mainly for guiding), horizontal sliding seat trim on the (horizontal / back), in order to get the ideal arc R. R R and R knife cutter blade, the knife edge is concave arc shape, the arc cutting edge is the tool, the tool will have different arcs in different sizes, most edge machine is used R2 arc, and the different is flat repair knife, the blade is flat, no arc. The profiling wheel is actually the vertical datum of the tool. When the plate is moving, the copying wheel is tightly attached to the plate to ensure the cutting accuracy of the cutting edge. You said that the taper wheel is not the part of the coating or the trimming part. If it is the part of the coating, the two cone wheels are usually set for the purpose of compacting the edge of the edge band with the upper and lower sides. When it comes to trimming, it works the same way as the copying wheel, unlike the copying wheel because it is a horizontal benchmark used to control the amount of cutting in the horizontal direction of the tool. Method of adjusting a lot of details, here is not to say, the general idea is that you can use a long plate, the section saw Qi, not sticky glue edgeband, so he went to the middle of the machine and then stopped, and then the profiling wheel and baroclinic wheel by flat plate to adjust the locking position then, on both sides of the cutting tool is adjusted to the sheet, cutting size can according to production needs to adjust. I don't know if I can help you with anything. It's always difficult to express it. I hope it will help you!
You should train a professional maintenance staff, even a good technician can not afford it!!!!! I have learned it myself! Edge banding machine is not easy to use!
