Home > categories > Hydraulic & Pneumatic > Angle Valve > Replacement of the toilet in one of the angle valve, why the entire family of water flow has become super small?
Question:

Replacement of the toilet in one of the angle valve, why the entire family of water flow has become super small?

Home toilet on the angle valve of Water Leakage, I changed a replacement, but after the emergence of a strange phenomenon, is the home of the water becomes super small, this is not only the main valve angle valve, the valve on the toilet, but why he changed after the whole house all the leading water becomes very small? Why? Why?To see clearly, oh, not the main valve, oh, put awayThe main valve has been switched many times, and the other one is very strange. When the other taps are changed, the place of the angle valve will hum

Answer:

This problem occurs frequently, must spend more on the total valve closed angle valve replacement, after boiling water, the pipe rust with water to the total valve block caused by water becomes small, may also be the stem off. Turn on the tap and tap the main valve. If not, you can only open the main valve to clean or replace it. The local time for the other leading angle valve will hum sound, this situation is caused by the inferior angle valve, angle valve processing and installation error, causing the spool in a longitudinal direction of people, in other water when boiling water. The vibration of the pipe flow causes the vibration of the angle valve core, the noise made by the rotation of the angle valve and the non rotating part, just like the wind whistle of dove. When serious, it can cause pipeline vibration, and cause water hammer noise and resonance noise. If you do not often use the angle valve, you can use cloth to wrap the breath, you can eliminate this sound, or replace the angle valve, the purchase should pay attention to selection, there is no longitudinal accumulation.
That and the angle valve does not matter, you check whether the installation of angle valve, the main valve is closed, not fully released, or the total valve problems. Try to open the main valve several times.
If the main valve has been used for a long time, or the quality is not good, it may be broken. So, when you turn it off, it's probably not in place. To determine if the problem is not here, then you look at the toilet angle valve position is in the trunk pipe position, if the other is the only way which must be passed with tap, it may be the angle valve screw is too long, with raw materials around too little, the dry pipe plugging part. Maybe it's the old stuff and stuff like that in that place. Proposed removal of angle valve inspection, the main valve to open, rinse, also by the way to see if the water pressure is large enough. If the water pressure is large enough, then the main valve will be out of order. Once reassembled, the problem should be solved. If you remove the angle valve, open the main valve or not much water, then it should be the total valve problem.
I guess your angle valve is leaking, so when you boil water, it will exhaust in the pipe, and you will be smaller
Not surprising.The first is to look at the size of the water in the neighborhood, and it is determined that the tap water pressure is getting smallerThe second is the tap water main pipe angle valve is connected to your home on the right, above is not three, the pipeline is iron or plastic, iron in the installation and water stop, and more will block the pipe, plastic melt to poke too deep will lead to blockage of the pipeline becomes small

Share to: