Shake head light, address code and console consistent, but not controlled, the address of this table lamp code for other lights
The console, signal line, flow signal amplifier signal lamp of the computer console (sometimes can not) - computer lamp (other signal lamp control) the seat - Kalong signal line -----I--- main chip which can analyze the 1. console problem. (although the probability is small, but I still doubt him) and a signal line (open circuit or short circuit can be measured with a multimeter out)
3. signal amplifier has a problem, (the general returned to the factory maintenance) lamps have a Kalong (such as card head and seat Kalong bad; some lamps qalun seat specially there is a piece of circuit board, there are 2 zener diodes), if they can also cause bad pull out of control) signal line between the 5. seat and the circuit board Kalong 6.SN75176IC problem with bad contact problems, so that the signal into it without output to the input pin of the main chip (CPU) 7.CPU main chip problem is not available, the received signal has 8. address code, or dial and switch problem is invalid. Another case is connected to the console signal lamps back without rules run into chaos, unplug the signal line can be a general signal line reverse pull (signal line in 3 small lines) have a switch or turn back, you can pay attention to the normal work of 9. seat Kalong mobile performance, the inside of the connection is broken, the short circuit will cause the lamp is not controlled or abnormal operation, interference, such as: if the ground three signals in the lamp is easy to pull off the interference of
10. sometimes connected lighting lamps in the last one can be out of the seat with a qalun output signal amplifier. Production method is in the Kalong 2-3 plug is connected with a 100 foot European resistance, sometimes because the signal line is too long without a signal amplifier will cause the lamp in the operation from interference or synchronization. Some although the signal line is not long, but due to excessive bending will cause interference.
