Small iron crusher various small motor
Tighten or replace the spring 1. spring 2. replacement thrust plate bearing 3. replacement thrust plate to re adjust the discharge port adjusting device of the flywheel with too loose loose 1. keys, keys and keyways wear 2. shaft locking device loosening the key matter, or change the key will reopen the keyway, the shaft end of the locking device to tighten jaw crushing product size increases at the bottom of the plate wear adjusting the discharge control device, reduce the discharge, if not, will be on the board under the jaw or replace the jaw crushing cavity blocked, the main motor current is higher than the normal operating current
The 1. big stones into the crushing chamber above, but it can not be broken caused by blockage of belt machine 2. crusher following failure, the discharge opening blocked 3. into the viscous material and other debris blocked 4. feeding discharging opening is too large 1. parking, with a rope tied a big stone, stone hanging out with a crane crusher 2. stop feeding, troubleshooting belt machine, dredge outlet. 3. reduce feed capacity, bearing temperature is too high, 1. grease less than 2., grease dirt 3., bearing damage 1., adding the right amount of grease, 2., after cleaning bearings, replace grease 3., change bearings
The major cause of failure may occur in severe splitting noise elimination method, moving jaw stop swinging, rotating flywheel to rod spring relaxation, broken into the cavity crushing cannot or other causes damage on the thrust plate pull rod nut, remove the spring rod, the movable jaw hanging, replacing elbow board crushing plate and jitter clash 1. crushing plate loosening bolts 2. fixed crushing plate 1. fastening bolt fracture crushing plate bolts, such as anti loose spring shortage should be replaced 2. replacement crushing plate fixing bolt flywheel rotation, broken stop, thrust plate from the bearing off the rod spring or tie rod fracture replace the damaged parts bearing thrust plate produced in the crash or other abnormal sound 1. spring tightness is not enough or relaxation 2. thrust plate bearing wear or relaxation of 3. thrust plate elbow head wear 4. discharge opening adjusting device to adjust is not uniform, Cause thrust plate around the work of inconsistent
