Solar water heater hot water pipe why burst
Use method and matters needing attention:1, full of water, throw the fastest half box water temperature, should try to keep the water tank full.2, master the water time, as far as possible in the evening or morning before the sun comes out of the water, and read the instructions carefully, master the function of the instrument.3, when the temperature is lower than 0 degrees, the best every day a small amount of water in the water heater, relying on water temperature to increase the temperature of the pipeline.4, pay attention to the weather forecast, when the temperature is very low, the evening will run out of hot water tank filled with water, and then in the nozzle or tap a basin, the water valve release point, let it slowly dripping, keep the water in a pipeline flow, avoid pipeline blocking.
2, when the tube in the water less, because of the high temperature steam boiling water to the nozzle to meet air condenses into water when the release of large amounts of heat, vacuum tube overheating expansion burst, but less likely.3, the vacuum tube due to leakage caused by heat preservation, resulting in water pipes in the absence of light when the ice, rising crack vacuum tube.
Hot water pipe burst of solar water heater:1, solar water tank without water, vacuum tube temperature during the day is higher, if the water at this time, due to the temperature difference is too large tube, the most likely.
