Home > categories > Consumer Electronics > Set Top Box > Standard remote control remote Gehuayouxian set-top box to re learn the TV
Question:

Standard remote control remote Gehuayouxian set-top box to re learn the TV

Two days ago my TV is broken, then bought a new, such Gehua set-top box remote control of "learning" in the region there is no response, it should be to learn new TV remote control system? How do you learn again?

Answer:

The way to relearn is as follows:1 press the settings button of the set-top box remote control for about 2 seconds. Wait until the red light is long and then release the settings button. At this time the remote control is on standby.2, the infrared emitter TV remote controller and a set-top box remote controller, TV remote control, press the standby button, the set-top box remote indicator will flash, then press the set-top box remote learning area of the standby button, the indicating lamp will become constant light, said the top the box has completed the standby button TV remote learning;3, and then you can install the above method of operation, learning TV remote control on other keys, such as volume keys, channel keys, etc..4, all keys to learn successfully, press the set-top box remote control settings button, you can quit the learning state;5, then the user can use the set-top box remote control on the TV button to control the TV, such as press the standby button to enable the TV to enter the standby state, press the volume key to adjust the volume of the TV, etc..
There are 2 kinds of learning methods, one is the first address, the other is the first address, then the information. You're going to have to experiment with that.Method 1 (first address, after information): put 2 remote control head to the head, the launching tube is less than 5cm of the transmitting pipe. Hold down the "learning" button or "Settings" button of the learning remote control. The indicator light is usually bright and prompted to enter the learning mode. Press the TV power supply for the remote control, then press the power button for the new TV remote control, then press the "learning" button or "set" button to quit. The rest of the keys are the same way.
Method 2 (first information, following address): place 2 remote controllers head to head, and the transmitting tube is less than 5cm of the transmitting pipe. Hold down the "learning" button or "Settings" button of the learning remote control. The indicator light is usually bright and prompted to enter the learning mode. Press the new TV remote control power button, then press the TV power supply of the learning remote control, then press the "learning" button or "set" button to quit. The rest of the keys are the same way.

Share to: