The electric hoist is down and the normal load drop will not move
Control GuiZhu power disconnected, the light control circuit and see if you have any questions, if not, the problem is out in the main circuit, check the wires have wear grounding short-circuit phenomenon, and the flow is too small.
In fact, the same kind of question is said on the website, and I'll give you some answers. You check, the main circuit has a virtual connection, the main point is the electric hoist to the wire switch after the connection and the main hook connection. The trip indicates that the current of the line is over the rated working current of the switch, and the electric current of the motor is only one third to one half full when it is empty. The cause of the trip is that the motor overload or switch is smaller. Measure the load current of the motor, and if it is normal, it is recommended to replace the large one.
Control GuiZhu power disconnected, the light control circuit and see if you have any questions, if not, the problem is out in the main circuit, check the wires have wear grounding short-circuit phenomenon, and the flow is too small.
