The gas stove was able to hit the fire, but once it was released, it began to bounce again
Ignition principle: open the gas stove -- white "ignition needle" issued red arc (Charlie para ring Mars) and heat - "thermometer" temperature - pulse ignition.
The solutions are:1, scrape off the probe needle oxide layer2, clean the probe needle"3, the "heat probe" to the "ignition needle" in the direction of a little break, or with the pliers to clamp the needle point.4, the ignition time a little longer (that is, do not immediately after the ignition switch loose, and so on, "heat probe needle" hot only pine)
The main cause of misfire:1, the probe needle oxidation2, the probe needle dirty3, the probe needle away from the ignition pin4, the ignition time is shortAll of these lead to the decrease of the sensitivity of the probe and the slow heating
In this case, it may be improper operation, or gas switch spring parts off.
