The great gods come out and turn to the ice maker without ice
If you can enter the ice off state, the heating pipe can also be normal heating, may be ice free time or heating valve is too small, you need to adjust the control board procedures, or replace the large heating valve. Generally speaking, this possibility is smaller and the product will be matched when it leaves the factory.In general, these are the possibilities that I hope will help you.
Through the above can be a big problem to determine the fault, and if you can not enter the ice state of normal, it may be the control panel procedures.If can enter the ice shedding state, the normal work of compressor, but the heating is not hot, there may be a part of the heating valve circuit, detection circuit to this part, in order to determine the fault of the heating valve, or control relay, or connection circuit problem.
Hello, this problem occurs, you need to observe the following questions:Whether the ice maker can enter the ice - free state or not, the general ice maker has the corresponding status indicator (you can refer to the manual). Look at the ice under the state of the parts of the work, normal if it is compressor work, heating valve open.If you can get into the ice off state, then off the ice, touch the heating pipe, the temperature of the back of the pipe, the general heating pipe is relatively hot, the temperature of the back of the pipe temperature. In addition, it was observed that the ice removal time was not caused by insufficient ice removal time.
