The grounding electrode 50 angle steel and the ground wire 50, the flat steel lap welding, according to the specification 169 needs the flat steel to be late 90 degrees, bends close to the angle steel side, the overlap width is 4 times (200mm)?
Flat steel and steel, flat steel and angle steel, in order to reliable connection, should be in addition to the contact regions on both sides of the welding, and welding with arc steel should be bent into (or rectangular) clips or directly from the strip itself curved (or rectangular) and steel (or steel) welding.
GB50169-2006 in the 3.4.2 stipulates that the grounding body (line) shall be welded by lap welding, and its lap length shall comply with the following requirements:1. flat steel is 2 times its width (and welded with at least 3 edges);2. round steel is 6 times its diameter;3. round steel and flat steel connection, its length is round steel diameter of 6 times;
