The method of repairing steel tape (I removed it, now the amount of parts can not be taken back)
How can you open your ass?. No way to put it back. First roll the inner coil as tightly as possible. It's hard to do with hand, then put the two outer shell together and fasten it
First of all, the inside of the spring (inside the layer of no words of any piece of steel) a little tight, not once, can be two times, until the end of the collection. Then cover and press the rivets.
Do not be impatient, the steel plate, spring and foot belt parts on a block, compared to the positioning pile on the shell to determine their respective installation position. Small clamping attachments and ruler mouth attachments are also carefully controlled. These things are sure good position, you can slowly around the spring and the spring steel, placed in the center position of pile, finger pressing, the other hand holding the tape around, try to close around. Fit the locking accessories and the limiting accessories. Buckle the other side of the box cover. Try the tightness. If not, then remove the box top and tighten it again. Pay attention to safety. The steel belt and spring are very sharp. Pinch it tightly when you pinch it. Wear gloves and protective glasses best. If it does not matter, first, someone (to do on security matters that the dabbler master)! Or go directly to buy one, very cheap, 35 dollars, ten dollars are good brands!
