The problem of poor chip removal, special reamer scraps can not be found out. What's the main problem?
The main reasons for the poor chip removal are as follows:1: cutting quantity is too large, feed speed is too fast2: the blade is too many, can change 4 blades for 2 blades3: cutting fluid pressure is too small or blunt point is inaccuratePay special attention to the processing of aluminum material, especially easy to stick knife, pay attention to cutting fluid in placeThe speed of the reamer should not be too high
Reaming is not large, resulting in little chip; most of the reamer is a straight edge, even with a spiral angle reamer is not in order to chip (although there is a certain chip removal effect). It's usually artificial chip removal.
Reaming is not large, resulting in little chip; most of the reamer is a straight edge, even with a spiral angle reamer is not in order to chip (although there is a certain chip removal effect). It's usually artificial chip removal.
