Not much time ago refrigeration. It's better to adjust the temperature. But found that the door did not open before the suction, and gently pull open.
(4) as a result of stretching, the length of the door seal is slightly longer than the original. Therefore, the excess part shall be cut off according to the original length, and the end shall be cut into 45 degrees bevel angle.(5) press the magnetic stripe into the entry seal according to the reverse procedure, then seal the door seal and glue the four corners of the door seal with 502 glue.It must be noted that when the plastic magnetic stripe is placed into the door seal, the large suction side shall be directed toward the case. The method of judging magnetic stripe suction is very simple. As long as the magnetic stripe is first tested on the box, it can be determined. In addition, the door seal and the box should be bonded at the same level as other seals.
(1) remove the refrigerator door from the box and take a sharp knife to cut the sealing joint of the four corners of the door opening seal;(2) remove the plastic magnetic stripe from the door seal and place it still on the case;(3) the door seal remove soak in hot water with 55-65 degrees Celsius in 4-6 minutes to salvage, two hand pinch door seals, door seals forcibly pull straight (uneven tension can not be too large, so as not to pull off) after placed on a flat glass, glass above then pressed on to after natural cooling, door seals will become flat and straight. If not once, can be repeated many times until the concave and convex disappear.
It may be that the door seal is aging, and the seal of the refrigerator door is aging, not only the door cannot be closed, but also the air conditioner is leaked.You can replace the door seal, the price is not expensive, about 10 yuan / meter.If there are no new door seals available for the moment, it is also possible to perform emergency repairs in the following manner.
