The spot welder often stops itself and points out that the spot welding is not finished and needs to be done manually. Why is that?
Contact bad ~ clean up the machine again
This is a lot of problem, you can check, PLC check the completion of welding signal steps have not received the completion of the signal.Normally, when a welder finishes a welding process, it outputs a signal to the PLC, and then PLC decides how to go next. This situation is vastly different, it is best to find the time to do this automatic spot welder manufacturers. Otherwise, you'll have to change all the control systems.If you change, you can find me, a lot of success stories.
The general problem is the control system
