Small strength Water Leakage afraid, afraid of the cracking gas to the wire, how to grasp the strength, good knot!As shown in the picture, this one is screwed up to the top!I just get, after wrapped with raw materials, with the hand in hand rotary rotary angle valve, when the screw does not move, I use a wrench to continue to twist, but did not feel how hard or easy to wrench to screw wrench, with two or three laps in position after no dare to twist again, not that is screwed to the stop position, because the screw is also afraid of explosion, two days of observation, there is no Water Leakage, ask such a situation, a map of water inside there may be screwed my crack, some people say that because the Internet force is too large, the wire twisted crack, need Zaoqiang slotted reconnect!
It feels like tightening. It's like you just can't screw it. If you're trying too hard, you'll have to screw the button inside out. That's the end of it.
Yes, do not go too hard to tighten the valve, in general, did not wait for you to tighten when it will not leak, and rest assured, do not force too much
Very scientific and rigorous answer is as follows: Ten Inch wrench 50N force as hard as possible to tighten 9.8N=1 kg, of course, to see whether the correct orientation of the nozzle(is it a little complicated?) In fact, the outlet to find a suitable location for the Water Leakage can not tighten as long as I forgot to tell you that you want to screw the water pipes burst really not easy to quality within the tooth bend looks really good quality but seemingly more general angle valve
