that is, how to make a turntable bearing 2 seconds to stop for 6 seconds, how to achieve ah, I hope the cost is a little bit lower, thank you all first. TenThe load on the turntable is one ton. If the motor is used, please tell me what type of motor it is
To consider too much, such as turn 2 seconds, the number of turns required or how much angle rotation, must be constant speed, construction, frequency conversion, programming, control, motor speed reducer
It's easy to go wrong! This is the impact load relative to the bearing!
The turntable weight is 1T. Should you install the plane bearings or slewing bearings in this rotating unit? Therefore, the motor needs to output torque just to overcome the friction, but also to ensure that no stall (that is, all the weight of inertia, calculate it)Forget to say that motors use brake motors. You can check it online.
With the motor plus reducer drive, with time relay control, very good to achieve ah? What's the problem?If you don't want to use this, use a cam splitter.
