Turning steel pipe, what is good?
The following two kinds of cutting tools can be used for cutting steel pipe:1 if the hardness is low, so it is sticking to the knife on the lower, available hard alloy cutter "," turning speed is slightly higher, the appropriate amount of feed, the additional coolant side.2 if the hardness of the steel pipe is high or the knife is high, it is recommended to use the diamond cutter". High cutting speed, feed rate, side car additional coolant.
The following two kinds of cutting tools can be used for cutting steel pipe:1 if the hardness is low, so it is sticking to the knife on the lower, available hard alloy cutter "," turning speed is slightly higher, the appropriate amount of feed, the additional coolant side.2 if the hardness of the steel pipe is high or the knife is high, it is recommended to use the diamond cutter". High cutting speed, feed rate, side car additional coolant.
Feed from you for the 0.307 to judge, should not be a tool, but feed selection is too large, normally used coarse feed 0.3 is not small, not to mention the eccentric shaft, suggestions will feed appropriate small try.45# steel is generally used in the case of the YT15 is more suitable, YT5 poor wear resistance, YS8 brittle easy to jump knife. As for the speed depends mainly on the size of the workpiece diameter, if you use the cutting speed to measure, then the general rough car with 60 to 80 meters per minute, fine car with a 80 to 120 meters, the eccentric shaft should be appropriate to reduce the cutting speed.
