Home > categories > Minerals & Metallurgy > Aluminum Foils > Drilling Aluminum? 1 and 1/2?
Question:

Drilling Aluminum? 1 and 1/2?

Two questions regarding aluminum pipe.1, can I drill a 1/4quot; hole through (entirely through) 1/4quot; wall 1quot; OD aluminum pipe without structuraly compromising it? 2, what the largest size hole I can drill through 1/4quot; wall5quot; OD aluminum without comproising it?By through, I mean so that it comes out the other side, looking like this from a side profile -O- Thanks

Answer:

Yeahyet Undertaker could make anybody look sturdy, and back then, there's a clean sturdy celebrity who would not could desire to look sturdy, a hell of a tournamentit extremely is why i evaluate Undertaker the suitedHe could make anybody look sturdywhat share circumstances do you notice a sturdy Mark Henry tournament? Like, 2 circumstances with UndertakerUndertaker is interior the suited tournament of great Khali's terrible profession (final guy status)significant vs significant are sparse those days because of fact they are so huge and slow (huge coach, Khali, Kanethose days Mark Henry and different fat people and a few superheavyweights)Undertaker, pondering he's a factor of the giants in wrestling section makes it even greater beneficial, because of fact it fairly is harder to do the flaws he doesHe flips over the ropes or walks on 2 inch flimsy metallici can think of of no different significant tournament (besides the actuality that Kane vs huge coach vs Raven at Wrestlemania replaced into cool)
Fit is everythingIt is a second bike, they are the same priceBoth frames are similarBuy the Giant based on fit.
Go with the bike that is the better fitThe Giant is a good bike, and it will have shifters incorporated with the brake levers, very convenientThe Schwinn may have been higher end, but the components are no betterI would go with the newer Giant, especially if it fits better.
Since pipe is designed to carry fluids, any hole will compromise itIf' however, you mean will it collapse, It will depend on what you are using it forI/4 inch thick pipe is quite strong but of course has limitationsPerhaps you should provide more details?

Share to: