Uninterrupted power supply tips
Ups can work for a long time as long as the normal power supply will not affect the ups and downs of life is not only affect your ups is just a moment to adjust the role of the current use of confidence with no problem
(2) press the UPS start panel "open" button, UPS power system will start slowly, "inverter" indicator light, delay 1 minute, "bypass" lights off, UPS to power supply, complete the boot.
After about 10 minutes of no-load operation, the load is started according to the load power from large to small boot sequence.
Daily boot
Just press the UPS panel "ON" button, about 20 minutes later, you can open the computer or other instruments to use. Usually after the start of the UPS to enter a stable work before you can open the load device power switch (Note: manual maintenance switch in the normal operation of the UPS, "OFF" state).
Shut down
First turn off the computer or other equipment, let UPS run for 10 minutes, the heat after discharge, then press the panel "off" button.
Uninterruptible power supply - how to extend UPS power supply time?
There are two ways to extend the power supply time of an uninterruptible power supply system:
1. External high-capacity battery pack: according to the required power supply time corresponding to the corresponding capacity of the battery pack, but be aware that this method will cause a relative increase in battery charging time, and also increase the area and maintenance costs, it is necessary to seriously evaluate The
2. Optional large capacity uninterruptible power supply system: This method not only can reduce maintenance costs, if the load equipment expansion, the larger capacity of the uninterruptible power supply system can still operate immediately.
UPS power system on and off
The first boot
(1) Closed in the following order: Energy storage battery switch → Auto bypass switch → Output switch is set to "ON".
