My computer has 3 USB ports, one is USB3.0, the other two are USB2.0, now is the mouse plug can be used in the USB3.0 port, the other two of the 2 are not inserted in the mouth of mouse but the mouse is bright, plug in the U disk can be used, this is what ah I think that is driving the problem when inserting the mouse shows what the driver installation failed, can not be detected which driver wizard driver is not installed, solution!
Insufficient power supplyMotherboard power supply problems are relatively largeYou can uninstall the mouse in the device manager and scan the device, perhaps you have used another USB mouseDrive conflict
The computer mouse didn't respond, probably for the following reasons:1, the power supply problem may be that the USB interface does not have data transmission and try using other USB interfaces;2, drive problems, reinstall the driver, or update the drive.Method：Using driver management software, you can test and install the driver. To drive life example, double click after running, click the "peripheral driver" can automatically detect or install.
1: the mouse entered a number of dust. Open the upper lid of the mouse and clean the dust inside.2: if the mouse with a rubber ball is the easiest to use because of dust, unscrew the cap, remove the rubber ball, and clean the dust on the wheel.3: may be caused by poor contact with microswitch, buy a switch, change it on, or the left and middle key switch swap, because the middle is not commonly used.4: if the new mouse does not move, it is likely that there is no installation of the mouse driver, it is recommended to download the official website driver installation. Or download Lu master installation prompt installation driver.
