Uv stone plate sticky method, what glue
Clean the surface of the UV board and clean the excess seal.
Water transfer joints, and then fill the joints in the two UV board 45 degrees angle intersection, first filled, and then the vertical angle of wood from the 45-degree angle at the intersection of gently across, so that the intersection of beautiful
1. In the wall covered with a grass-roots level, commonly used is 3MM plywood, woodworking board, a good point is the fire glass magnesium board. With nails to nail them on the wall, and with a sandpaper to clean the board.
2. Saw board, the UV high-gloss decorative panels according to the actual requirements of a block into a block.
3. Flip, will be installed on the four sides of the UV board with a chamfering machine down to 45 degrees angle. According to the actual installation requirements, and some just down the next two sides or three sides.
4. Clean the back of the UV board, clean the back of the UV board with sandpaper and rag.
5. The universal glue or wood glue evenly coated on the back of the UV board, and then the UV board flat on the wall, and then gently hit the UV board, so that UV board more firmly stick to the wall.
