hi , i got some electronics frm asia( like camera and hair dryer) , which can only be used in 220 volts. which converter or transformer sud i use which changes 110 volt to 220 volt ? and where can i get it ? i searched for it . but i found converters that change 220 v to 110 volt :(
No, a stick welder is going to tug approximately 9,000 watts at an identical time because it truly is arcing (often use), extra if it truly is cranked to 230 amps (at around 50 volts on the top could require 11,500 watts). you may no longer run that many watts by using any hassle-free a hundred and ten-volt circuit, that's many times constrained to 2,two hundred watts (even for short-term use). you will desire a welding receptacle put in, many times close to the key panel or subpanel, utilising thick wires and a 50-A, 220-v circuit breaker, or greater, based upon the standards for that unit. it might value approximately $50 in factors and $a hundred and fifty in hard artwork, if it truly is an exceptionally short run.
Check Hammond, they have auto transformers that can be wired either step down or step up. You need to know the total wattage of the devices you have , and choose the largest one. Frequency, hopefully, is not an issue here.
Yes, You can buy a converter that allowes you to use Asian Ele. Item (220V) in USA (110V). It is very easy to use. One end you will fix to the power outlet and another end with your item. Size? you can keep in your puce
