Wallpaper interface will appear "black bars" is how is it?
4, with the pressure roller from top to bottom will be flat pressure, pay attention to lcm for a flattening, each section up and down three times, the force can not be large, should be light and uniform.
3, if the overlap occurred in the case of joints, should first hand gently move over the overlay of the wallpaper, so that two wallpaper overlap, and then use the scraper to repair the joints.
2, with a blade at the tip of 1cm and 30 degrees with the wall gently flatten the seam.
Seal processing
1, with a knife to open the joints, with a special small brush, carefully from top to bottom, coated with special glue (wallpaper powder and white plastic ratio of 1: 1), brushing, to 1cm l segment, brush two , Try not to glue the surface of the wallpaper overflow, if overflow, should immediately wipe with a white towel or sponge.
Generally due to the construction of the overflow when the glue is not caused by clean, glue exposed, over time will be covered with dust and bacteria.
