What are the precautions in the process of recovery of pollution and regeneration equipment?
6., regularly check whether the operation of the normal institutions, there is no noise, such as the discovery of failure, must be promptly removed.7. installation, disassembly and adjustment of rotating mechanism, should pay attention to ensure that the rotating mechanism reducer central line and gear central line parallel, and its meshing surface is not less than 70%, meshing clearance should be suitable. Tmall America tips: haze travel, remember to do a good job of protection.8., the motor encountered overheating, to stop in time, after troubleshooting, and then continue to run, the motor bearing lubrication to be good.9. each control box, distribution box and so on often keep clean, clean the dust on the electrical equipment in time.
3. cyclone, vibration sieve, slag pump and other parts should be checked regularly to ensure their normal operation.4. regularly check the connection of each part of the sand recovery machine. If it is loose, it should be tightened. The bolts should be in the body compression check tightness, a little shaft all connections must have openings, and need to fully open.5. check the sand recovery machine for all the wires and cables regularly. Bind and replace the damaged part in time.
Note the use of sand recycling machine machine Braun think this is mainly due to the daily use of details, if daily use pay more attention not to damage the machine, it can prolong the service life of the machine, so the Braun listed items in some sand recycling machine for daily use should pay attention to.1. after the sand recovery machine is installed, the institutions should check and adjust regularly to ensure the flexibility and reliability. In the friction surface, there should not be any dirt, dirt must use gasoline or thinner wash.2., should pay attention to check each department screw has broken wire and loose stock phenomenon. If it exceeds the relevant regulations, it must be renewed immediately.
