What are the requirements of ice maker in purchasing?
1, ice machine should not be placed in the outdoor environment, it is best to install in a safe, clean, well ventilated environment, and do not be direct sunlight and rain.2, ice machine can not be near the heat source, the use of the environment can not be less than 5 degrees centigrade, not higher than 40 degrees, so as not to affect the temperature of the condenser too high heat dissipation, can not reach a good ice making effect.
5, ice machine should be used in accordance with local drinking water standards of water sources, and installation of filters, to remove impurities in water, to avoid clogging water pipes, pollution tank and ice mold, and affect ice performance. The minimum water temperature is 2 degrees centigrade, the maximum is not more than 35 degrees centigrade, the lowest water pressure is 0.02Mpa, and the highest is 0.8Mpa.6, ice machine must be two months to unscrew the inlet hose head, cleaning the inlet valve screen, to avoid sand, mud, impurities, blocking the intake, and cause water inflow, small change, resulting in no ice. Although the ice machine ice making process at the end of each time, will put in the sink after water cooled off, in order to achieve the cleaning effect, it can effectively reduce the scale of evaporator and water circulation system in production, but generally about six months, also want to use ice machine cleaning and disinfection agent on the water pipe, water tank storage, refrigerator and water retaining plate for cleaning and disinfection, and rinse, produced in the cleaning process can not eat ice. When it is not used for a long time, it should be cleaned and dried with an electric hair dryer. The ice mould and the water in the box shall be placed in non corrosive gases and ventilated and dry places, and outdoor storage shall be avoided.8, handling ice machine should be handled with care, to prevent violent vibration, handling slope can not be less than 45 degrees, after long distance transportation, ice machine should be placed 2-6 hours before you can start ice.
3, ice machine should be installed with a smooth platform, and adjust the bottom of the machine screw to ensure that the machine placed level, otherwise it will not cause ice and running noise. There should be space around. In order to facilitate heat dissipation, the left, right and back space of the machine must not be less than 150mm.4, ice machine should use the provisions of the national standard of independent power, the power supply should ensure reliable grounding, and equipped with fuses and leakage protection switch, voltage fluctuation shall not exceed the rated voltage of + 10%.
