When I had my water tested they said there was copper in my water. When I called the water department they said it was because of the pipes in my house. So what can I do about it. My tap water tastes terrible and that‘s WITH using one of these Brita filter pitchers - it still tastes nasty and usually I end up not drinking any water unless I get bottled water which gets really expensive and I end up drinking juice, soda, alcohol, milk, etc. but I‘d rather just drink water.
I suppose you could have you pipes replaced with plastic. Most homes have copper water pipes but do not release enough copper to change the taste of the water or cause a high level of copper. Personally I would have your water tested by an independent Lab. A true test of your water would be to test the water just before it gets to your house (not at the city waters well or distribution site) and compare it to your tap water, some of what you are experiencing could be in the pipes owned by the city and the city may or may not know that they have a problem and they may not. By the way filters for drinking water vary in what they can remove from water, if you read the label on a filter cartridge it should tell you what it will remove from the water but may not tell you what it will not remove. Good Luck Wish I could help more.
Use PEX and the recent Shark fittings - the stuff is quite impressive and could enable you to do perform a little quite fancy paintings in an exceedingly couple of minutes, a ways quicker than with sweat-copper. the fee would be aggressive as you could fish PEX precise up by way of partitions and around corners on a fish-twine as you may electric cables - so exertions is very much decreased. there's a business business enterprise referred to as Houseneeds (linked under) which will help you interior the path of the completed technique, communicate you by way of issues over the telephone (now and returned even at unusual hours) and many times be very effectual - besides as sell you stuff at quite sturdy expenditures. in spite of what some might think of this is not any longer rocket technological know-how. It in simple terms demands care, interest-to-element and a few undemanding prepare. have been you to desire to pass returned in copper, or in spite of solvent-weld percentCPVC fittings, i might give up you and advise you call a expert. yet with the recent PEX equipment and suited fittings issues are growing to be to be plenty greater handy the two to understand and to do. be conscious: a million,3 hundred feet rancher - approximately one very long day's paintings for 2 particularly adept persons to plumb the entirety inclusive of a water heater, washer, dishwasher, 2 baths, outdoors hose bib and so on - *THAT* is the superb thing approximately PEX plumbing. And that would incorporate a suitable manifold with person, valved warm and chilly feeds to each region. Lose the manifold and do series plumbing - a short day for 2, long day for one.
This happens sometimes when pipe are new and you let the water sit for a long period of time (several hours) and then draw water without letting it run for any period of time. After a few weeks and months go by, the inside of the pipe will develop a coating of copper oxide and that should reduce the taste problem. Running the water for a period of time sufficient to bring fresh water from the water main should eliminate the taste - if it doesn't, then the taste may be in the water supply itself. Check with your neighbors - ask them to fill a glass with water from their supply (even an outside faucet would be fine, just don't run it through the garden hose) - if their water doesn't taste bad and yours still does, get a plumber to check things out - it's remotely possible that someone stuck something into a pipe (or it got in there accidentally), and is contributing to the taste. You might first try flushing the pipes by just opening a few faucets at the extreme end of the plumbing - sometimes with several faucet running at once, you can push debris out of the pipe (where it sometimes ends up in the aerator screens, so you might remove those first). Plug the sink if you suspect there's something in the pipe so you can see if anything comes out. Again, this is only a possible cause if the house is newly built.
the oil pump could have locked up and made the distributor shaft quit turning. if that,s the case then the distributor shaft probably have to be changed also and a new oil pump.
