What do you mean by the side of the plastic mould
The division of heaven and earth is on the injection molding machine, the mould is on the injection molding machine, the upper side is the sky side, the lower side is the ground side One, on the side of the operator's operation, is called the operation side, and the other side is a side that deviates from the operator's side, which is called non-operating side or back 2, water in and out generally cannot be done on the operating side, for safety (some of the moulding hot water, if the detonation tube can burn the person) and the operator is convenient; The waterway is generally in the non-operational side, followed by the ground; It is also not advisable to use water in and out of the water, because if there is a leak, it will flow to the mold section and increase the injection rate. Inevitably, the water will flow through the channels through the channels
If there is a hot flow in the mold, the hot channel groove is usually on the side of the sky, and there is not much requirement on the non-operating side 4. The slider is in commonly day side nor desirable, inevitably will put the day side slide block increase the sliding distance, slip out of, if the slider with inclined guide pillar slider need to increase the slider spring and preloading is sufficiently large, oil cylinder oil cylinder or sliding out to you as far as possible self-locking mechanism, prevent unloading to slip sliding block, have the place to add the slider spring double insurance
When the mold is put on a plastic injection machine, the top and bottom of the molds are the world. The general sliding block type is not done in the direction of the world, most of which are horizontal. Prevent the slide from automatically falling off and smash the die.
When the mold is in place, the main view can see the top of the board.I hope my answer will help you.
