Home > categories > Hardware > Screws > What is a self-tapping nail? Is it used? What are the characteristics of the shape? What is the difference with ordinary screws?
Question:

What is a self-tapping nail? Is it used? What are the characteristics of the shape? What is the difference with ordinary screws?

What is a self-tapping nail? Is it used? What are the characteristics of the shape? What is the difference with ordinary screws?

Answer:

Ordinary screws need to be fitted with nuts, or with the tolerance thread. Self-tapping nail body with self-tapping thread, you can directly into the wood, walls and other fixed use.
Compared with the common screw thread, in the same large diameter, the pitch is small and small diameter is slightly smaller, has been standardized. Self-tapping screw material can be divided into two kinds of carbon steel and stainless steel, carbon steel materials which are usually used in 1022 medium carbon steel. Usually used in doors and windows, metal. The head is the end of the end of the shape of the part of the formation of the formation of the surface.For thread forming and thread cutting self-tapping screws (self-tapping screws), the flat top buried, flat round countersunk, pan head, hexagonal and hexagonal wire Head of the most important, these five head type accounted for almost all 90% of self-tapping screws, the use of self-tapping screws (self-tapping screws) should first consider this.
Self-tapping screw head shape with round head, flat head, semi-countersunk head and countersunk head and so on. Materials generally carburized steel, heat treatment after the surface hardness of not less than 45HRC.
Self-tapping screws are in the metal or non-metallic materials in the pre-drilling in the self-drilling with a threaded thread with a threaded fastener. Self-tapping screws with high tension, single, unilateral combination of features. Self-tapping screws are used for connection between thin metal plates (steel plates, saw boards, etc.). When connecting, first thread the bottom of the connector, and then screw the tapping screw into the threaded bottom hole of the connected part. As the tapping screw thread surface has a high hardness (≥ 45HRC), can be connected to the threaded bottom hole in the internal thread, thus forming a connection.
Is the head with a sharp screw, turn the screwdriver can be automatically drilled into the object, divided into stainless steel and galvanized and colorful three

Share to: