What is the clearance between the impeller and the cover plate of the flotation machine?
(3) the mass fraction of pulp has a great influence on the volume of inflation and the degree of dispersion. As a result of the increase of the mass fraction of the pulp to a certain limit, the volume of gas charge and the degree of dispersion also increase. However, the mass fraction should not be too large.(4) feed volume. When the amount of the pulp entering the center of the impeller is optimum, the maximum amount of gas is taken. Because in a certain range of large amount of slurry, when the slurry is thrown out of the centrifugal force is also large, the formation of negative pressure zone high vacuum, so that the amount of inflation increased. However, if the amount of slurry is too large, the slurry will clog the air cylinder above the impeller and cause difficulties in breathing
(1) the clearance between the impeller and the cover plate. This gap affects the volume of gas, the gap is too large, the pulp will turn to the front from the leaf blade at the rear lower vacuum behind the blade, the air flow decreases; the gap is too small, the impeller and the cover plate is prone to impact and friction, and the inflation quantity decreased. The experiment proves that the suitable clearance is 6 ~ 8mm.(2) impeller speed. In a certain range, the greater the impeller speed, the greater the amount of inflation. But if the speed is too large, the impeller cover is worn fast, the power consumption is increased, and the pulp surface is unstable.
Clearance adjustment between impeller and cover platePractice and theoretical research have proved that, in a certain range, increasing the volume of gas can greatly improve the production capacity of flotation machine and improve the flotation index. There are many factors affecting the volume of flotation machine, mainly from the following aspects of adjustment:
