What is the composition of the heating system?
1, boiler: heating and provide hot water device. At present, the general use of gas-strong row of boiler. 2, sub-catchment: the hot water assigned to the need for heating areas, divided into manual and automatic two. (Installed do not sub-water collector) 3, the cooling device is: a heat transfer of hot water to distribute, to achieve the heating needs of the device. At present, there are two common forms of radiator, low-temperature floor radiant heating (referred to to warm) two forms; also wall warm. 4, temperature control system: A, boiler linkage thermostat: According to the indoor temperature control of the automatic operation of the boiler, at the same time with programming timer switch function. Can not be achieved sub-room temperature control. B, sub-catcher linkage thermostat: According to the indoor temperature, control sub-collector on the electric actuator switch to reach the temperature of each heating area. (Generally used to warm) C, automatic thermostatic valve: According to the temperature control valve set temperature, automatically adjust the size of the water flow within the radiator to achieve the temperature of the device. (Generally used for radiator heating) A and B above two products in principle can not be used at the same time.
Boiler units, outdoor pipe network, indoor pipe network and radiator and other equipment
Heating systems, heating systems, boiler systems, outdoor pipe networks, indoor pipe networks and radiators. The energy consumed by the traditional heating and heating system is fuel, and the energy consumed by the electric heating and heating system is electricity. Therefore, in the environmental protection requirements of high urban heating and heating, coal-fired boiler room or coal-fired stove will be strictly limited to use, replaced by several possible forms of heating are mainly concentrated heating of the saucer segment Boilers, large electric heat pump and gas boiler room and scattered in the user's room within the home gas stove, electric heater and so on. At the same time, in order to reduce the power grid power generation peak and valley difference, but also consider the heating system set up in the heat storage device, so that meet the heating requirements at the same time, the load on the power load play a role.
