What is the connection of the LEDT5 lamp tube, the main line is how to connect, only to the end
Yellow lines don't have to be yellow to be ground.I hope my answer is useful to you.
1, the installation: The LED comes with a constant current source, which does not require a ballast and a regenerator. General T8 lamp tube because the lamp tube space is big enough, constant current source can be installed in the lamp tube. So, when installing, you can remove the ballast from the original frame and remove it, and install it directly. T5 fluorescent lamp, T4LED because tubes is very small, not put constant current source, can only be constant current source in a scaffold, so, T4 / T5 general manufacturers are doing, will deploy stents, stent in persistence current source, and the lamp installation direction of the. The direction is reversed, the lamp is not bright. We are considering adding some switching circuits to allow the lamp to work properly even if the lamp is in reverse. Voltage: to communicate 85V -- communicate 245V, all can work normally. However, the long-term voltage is too high or too low, which can affect the power factor of the constant current source, which means that the effect of energy saving will be slightly affected. At the same time, it can also affect the lifetime of the constant current. So, want to choose the fluorescent lamp that is appropriate voltage commonly.
You look at the instruction manual, this kind of lamp does not lead to ground line, see if can adjust brightness? Or the color palette? But such a small lamp is almost impossible to implement, or the yellow line is simply suspended, and the usual ground line is the outer shell of a metal shell
