Home > categories > Mechanical Parts & Fabrication Services > Housings > What is the danger that the gap between the outer ring of motor and end bearing seat hole is too large?
Question:

What is the danger that the gap between the outer ring of motor and end bearing seat hole is too large?

What is the danger that the gap between the outer ring of motor and end bearing seat hole is too large?

Answer:

Harm, long time, so that will make the motor and the stator rub each other, the motor will heat or sweep boring, increase the loss of bearings
Will run outside ring, serious cause motor sweep chamber, burn winding.
The gap between the outer circle of the motor bearing and the end cover and the bearing housing will cause the shaft of the motor to cause radial sway and axial movement. The motor will vibrate when it is running, which will seriously affect the balance and life of the motor coupling or pulley. The wear and tear of the motor bearing support gradually increased, and the rotor sweeping fault occurred. Motor bearings are liable to damage.

Share to: