Home > categories > Minerals & Metallurgy > Fiberglass Fabrics > What is the difference between alkali resistant fiberglass mesh and hot dipped galvanized steel wire mesh?
Question:

What is the difference between alkali resistant fiberglass mesh and hot dipped galvanized steel wire mesh?

What is the difference between alkali resistant fiberglass mesh and hot dipped galvanized steel wire mesh?

Answer:

Alkali resistant glass fiber mesh cloth has little effect on the strength of base layer, and can not effectively disperse the load of tile decorative layer on the base layer, and the load directly acts on the insulation layer of lower strength.
But it has been proved that the enhanced double-layer reinforced alkali resistant fiberglass mesh fabric is enhanced, and the alkali resistant fiberglass mesh fabric is superior to the hot-dip galvanized steel wire mesh in alkali corrosion resistance and construction operation.Silver YT inorganic active wall thermal insulation system is a new type of non net insulation system, do not need mesh, rivets, also do not need the mortar and plaster mortar, just add water, stir the smearing on the wall, the insulation layer outside the tiles or paint directly.
Mesh is enhanced tensile strength parallel to the direction of the vertical intensity has no obvious improvement, failure surface after drawing were concentrated on the surface of the glass fiber cloth, both single-layer glass fiber mesh cloth or double glass fiber mesh reinforced with brick are not recommended.
Alkali resistant fiberglass mesh cloth softer can only play the deformation of dispersing stress (deformation temperature, deformation and outside) to plaster layer sharing under tension. When the glass fiber cloth mass per unit area increases, the tensile bond strength of tile is bigger, but the increase is not obvious. When the glass fiber cloth mesh size increases, the tensile bond strength of brick decreased after increasing.

Share to: