What is the difference between a hot melt connection and a hot melt connection?
Data line caused by poor contact, with a little bit of data cable, as well as the charger output current to 1A, USB interface to be able to support Apple's mobile phone.
Cable YJV-1KV-5 * 10 pipe laying sets of "power cable laying cross-sectional area of 35mm ? within the" fixed, but also the coefficient conversion, the coefficient is the number of provinces to see the installation of fixed cable section description inside the "three-core and three- 10 mm ? within the "copper power cable is how much
It seems that this problem is more common in IPHONE. And most of the online answer seriously misleading, basically take it for granted. I share with you my own personal experience. I have encountered this problem today, the new car to buy a charge, a charge that does not support the use of this accessories charge, began to think that is the data line, but for many innumerable line did not solve. Charger with the original, IPAD, notebooks do not line, all show the same tips. Obviously not the data line and charger problems, because a few days ago also line. Remember that there have been bad contact before, and then plug several times to restore the situation, suspected that the data line and IPHONE4 tail plug contact caused by bad. With a needle, blade, brush and other cleaning tail plug, come up with a lot of paper and other dirt, power completely back to normal, regardless of that data line or charging equipment. Practice proved that this failure is completely IPHONE4 tail problem, at least I was like this. The so-called tail is IPHONE4 and USB cable connected to the site, that place is easy to enter the dirt, over time will lead to poor contact with the USB cable, it is recommended that you usually use a small rubber plug. I used to buy mobile phone sets when the buyer to send, then thought that no use lost, it seems it is still necessary.
