What is the difference between the zinc plated color guide and the profiled steel sheet?
Because the original plate is very thin, the quality of the anticorrosive coating directly affects the service life of the profiled steel sheet. In order to meet the requirements of processing and rust prevention, the coated steel plate shall be examined in accordance with the relevant provisions. Under normal circumstances, thin steel plate can also be used according to the requirements, after pressing type, and then coated with anti rust paint, or use stainless steel sheet, the original plate.Profiled steel sheet used in industrial plants, housing panels, wall panels, in the absence of general insulation requirements, steel per square meter of about 5~11 kilograms. Insulation requirements, availability of mineral wool board, glass wool, foam and other insulation materials. The profiled steel plate and the concrete are combined into a composite floor board, and the wooden formwork can be omitted, and the utility model can be used as a load-bearing structure. At the same time to strengthen the binding force of steel sheet and concrete, should be pre welding studs in steel plate or pressing two-way stiffener
Profiled steel sheet Yaxing, GangBan, English Name: profiled steel sheetRoof and wall panels are usually 0.4 to 1.6 millimeters thick and used for load-bearing slabs or silos with a thickness of 2~3 millimeters or more. The wave height generally ranges from 10~200 mm. When not reinforced, the ratio of height to thickness should be controlled within 200. When the long roof panel, the slope can be used from 2 to 5%, while the deflection is less than l/300 (L for the calculation of span length). At present, part of the waveform used in the construction is shown in Figure II, commonly used for profiled steel sheets.Because the original plate is very thin, the quality of the anticorrosive coating directly affects the service life of the profiled steel sheet. In order to meet the requirements of processing and rust prevention, the coated steel plate shall be examined in accordance with the relevant provisions. Under normal circumstances, thin steel plate can also be used according to the requirements, after pressing type, and then coated with anti rust paint, or use stainless steel sheet, the original plate.
The difference between the zinc plated color guide plate and the profiled steel plate is as follows:1, plated aluminum plate is pure aluminum 99%, and aluminum zinc is generally divided into 5% zinc plating and 55% aluminum zinc.2, zinc plating in zinc plating on the basis of the development of slowly, and 5% and 55% refers to the aluminum content.
