What are the cycles and requirements of the experimental project of the power cable experiment?
About 35m distance, with the copper clad aluminum wire, so that basically do not affect the electric car charging voltage. The best use of plastic leather wrapped copper wire, if the copper wire, then the wire will increase slightly, but will not affect the electric car charging. Only the line is too long, the wire sagging pull the charger will be the output of the end of the wire, which may be the charger inside the solder joint pull off. To solve this problem is to extend the output wire, the charger should be fixed to the output line, so as not to affect the charger. I hope my answer will help you. -------------------------------------------------- -------------------------------------------------- -------------------- The above content is based on "stupid do not know" personal experience to write, only on behalf of personal views and opinions, no one shall arbitrarily modify, It is forbidden to plagiarize. Please refer to the source.
In addition to considering the security issues, there is no problem, you can use this, there is no impact on the charging situation, rest assured
Two should be phase line, generally in the three-phase loop corresponding to the color: A phase is yellow, B phase green, C phase red, neutral (that is, zero line) for the blue. If only in the single-phase loop only red and green when the default is red for the phase line, green for the zero line. But not necessarily, some electricians do not follow the requirements, the specific you have to use the pen to know what the
