What is the reason for the continuous burning of several steps
If the voltage is too high, the nameplate on the motor is rated at the rated voltage, unless the designer has a problem
Mostly still maintain the voltage not adjust good, usually the purpose of the operation stop will be the last one pulse delay do the work of a solid position, but then change to the output should be much lower voltage. If you ignore the link, you may soon burn the motor. This has nothing to do with the concrete operator, it is the programming that is not in place.
The actuator is not compatible with the motor, which means that the minimum breakdown current of the driver is greater than the rated running current of the motor 2, you didn't go to adjust the drive current segment, default factory value, cause now is greater than the current running current rating of the motor (similar to the first point, it is a current running) The problem of the quality of the motor is that the temperature rise is too high, or the surrounding heat is so bad that the insulation inside the motor is damaged, causing the short circuit 4, drive and electrical wiring error, it is A + and A -, B +, B -, you take A order wrong, then into A +, B +, -, B - (that is to say, at the same phase, but you put together the different phase) 5, motor overload There should be other reasons, just for a moment. You check your drive and your motor and check what went wrong.
