Home > categories > Home Appliances > Ice Makers > What is the reason why ice doesn't fall when the ice making mechanism is ready?
Question:

What is the reason why ice doesn't fall when the ice making mechanism is ready?

What is the reason why ice doesn't fall when the ice making mechanism is ready?

Answer:

Reason two: ice dish is too dirtySolution: wash the ice pan. The ice dish is usually cleaned with a gram and acid liquid.Three reasons: the ice tray sealing offSolution: positive ice sealed off, take out a direct sealing off, opposite brass desoldering, see replacing the ice tray. If it can be repaired and welded well, consider welding.
One reason: the ice is too thin, so that the ice has not dropped, it all on the ice tray, from the new second plates.The solution: adjust the ice thickness probe. If the screw is adjusted, screw the screws inward and thicken the ice. That is, the thickness of the ice probe iron plate away from the ice plate, not block the more thick, but the thinner.
In the daily use of ice maker, the phenomenon of ice falling often occurs in long years of machines, and the problem is analyzed and solved:
Reason four: ice plate metal and edge of the plastic parts split apartThe solution: remove the gel from the opening.Reason five: condensate water discharge is too large, defrosting, there are condensed water in the rowSolution: adjust the pressure stop valve, let the water down a little.Reason six: defrost valve does not openSolution: defrost valve to connect 220V power, see if it can turn on, and if it can be opened, it is a computer board fault. Unable to open where the defrost valve fails and replace the valve.

Share to:

Hot Tag