I want to do stage lighting design, I found KTV, the bar inside a variety of flashing, change the color of the lights, what software is made out?. Is it PLC? So, can C++ make it out?
5, mixer even if the former is also input device, play music, sometimes use professional sound card, because this sound quality is better. If you have a multi track recording, you sometimes use a sound card. However, many digital console is also a sound card at the moment, very convenient.
.3, stage performance basic outfield (facing audience) is stereo, namely two paths. A particularly large place sometimes is a single channel (a road) PA. Sometimes the speakers are wide and the center is mid.For the echo, usually signal 2-8 range, in the electroacoustic band performance, basically every speaker on the stage of the sound is different, this is the sound engineer should be adjusted to the requirements of the actor.4 audio, lighting, and screens are controlled by different teams. When special programming is needed, the synchronization of their messages can be done using time codes, but usually controlled by the director through intercom devices.
Stage lighting should start with microcontroller programming software.1, the stage speaker management software, usually control the digital mixer, as well as speakers, processors, or effects of the device. As for the broadcast, there are hardware using playback equipment, there are software, and in their own use, often Mac, iTunes to play management. In acoustics, the audio engineer usually uses a software spectrum analyzer to detect the spectrum or squeal points.2 unless special needs are required, the stage signal does not need to be output to the decoding device. If the signal process, there is a general source - mixer - processor - amplifier; decoder refers to the processor, the moment signals are passed through the canon, may be the future network
