For adhering glass film to windows, you should be careful at every step, otherwise the film will be crooked or crumpled. 1. Clean the glass. Wash the glass thoroughly to make sure there is no soft flocks, dust or sand on the glass. 2. Cut the glass film according to the size of the glass. 3. After cleaning the glass, spray some water on it. 4. And meanwhile spray some water on the glass film and protective?film, and separate the protective?film from the glass film. 5. Scrape the water between the glass film and the glass slowly, and trim off the excess glass film at corners.
Method of adhering glass film to the window: 1: The film is divided into two layers, of which the transparent one is called negative film, and the other with gum is called positive film. The film is very brittle, so please don't touch hard objects or fold it. Adhere the film indoors. 2: Wash the glass more than three times with pure water and a small amount of liquid detergent. 3: Before adhering the film, spray some water again to facilitate the positioning and movement of the film. 4: Stick the corners of solar?film with a small piece of tape, and gently pull open the transparent film layer. 5: Spray water uniformly on the gum of solar?film to prevent it from sticking impurities. 6: Scrape off the water evenly from the middle to both sides.
Method of adhering glass film to the window: 1. Clean the glass. Wash the glass thoroughly to make sure there is no soft flocks, dust or sand on the glass. 2. Cut the glass film according to the size of the glass. 3. After cleaning the glass, spray some water on it. 4. And meanwhile spray some water on the glass film and protective?film, and separate the protective?film from the glass film. 5. Scrape the water between the glass film and the glass slowly, and trim off the excess glass film at corners. Adhere glass film to the window: 1. For film cutting, the film should be over 1cm larger than the glass in size. 2. The film is divided into two layers, of which one is colorless and transparent protective film, and the other is colored glass film. 3. Adhere the protective film and scrape water thoroughly from all directions to make sure there is no bubbles in the glass film. Matters need attention for adhering glass film to the window: 1. Whether the wiper blade is flat and smooth, and whether there is existence of gap. Be sure to check the tool carefully. 2. Check the size and number of the film. 3. Window size measuring should be started from the same side of the window. The edge of the film must be aligned with the center line before film cutting. 4. After all the windows are adhered film, spray a small amount of detergent on the glass to remove other residues. Wipe with a dry cloth to make the window smooth and bright.
