What specifications should be used for edible oil filter cloth?
Vinylon for clothPerformance: chemical name of vinylon cloth called polyvinyl alcohol, its strength is lower than polyester, strength is only3.52 - 5.72Cndtex. Elongation of fracture ranged from 12% to 25%. The elasticity difference, the fabric maintains the shape to be bad, the abrasion resistance is good, the durability is 1 - 2 times compared to the pure cotton. But there is one of the biggest advantages is able to withstand the strong effect, and good hygroscopicity, and easy rubber together, is a good material used in rubber industry, it is the shortcomings of low temperature, the temperature of 100 DEG C has no shrinkage, acid resistance.
General recommendations in 70-100 degrees can be, not hot Oh, don't put the filter and filter cloth are ruined Oh, ha ha, this we also worried that the viscosity decreased, oil is not used? The oil can be restored to its original viscosity after cooling. Also, it is better to add filter aid before filtration.2. filter material difficult to clean up?3., mud cake relatively high oil content?The main filter time is not enough, there are filter cloth ventilation hole caused by, wait until the plate filter press oil outlet out of the oil very little, you can open the plate and frame discharge. The smaller the oil out of the oil outlet, the more dry the cake.And the choice of filter cloth is very important. This is the most important thing.
Uses: used for alkaline strong manufacturers and rubber industry.Product model: 295 - 1, 295 - 102, 295, 1, 104, 295 - 105, 295 - 107, 295 - 114, 295 - 1 ()A lot of people ask, edible oil filtration effect is bad, basically be to have in this respect:1. slow filtration rate2. filter material is difficult to clean3. mud cake relatively high oil contentWe can analyze these problems1. filtration rate is slow?Oil itself is viscous, the flow rate is much slower than water, this is real, to improve the flow rate, only to the oil heating, the higher the temperature, the faster the flow rate, in order to increase oil flow, and reduce viscosity.
