What to buy furniture to see?
The selection of furniture needs to check whether the flat floor furniture legs. This point is placed flat on a glance, some furniture only three landing legs. Take a look at whether the table top is straight. You can't bend your back or lower your waist. The table top is raised and the glass plate is turned on; the table is recessed and the glass plate is pressed and crushed. Check the door, drawer joints can not be too large, should pay attention to the horizontal and vertical, Siemens does not sag.
Pay attention to the materials used for furniture. The surface materials of the furniture, with a hard Zamu asked, like ash, oak, relatively strong, capable of bearing load, and the internal materials of other materials are available. Coat cabinet leg thickness requirements of 2.5cm, too thick to appear clumsy, thin, easy to bend deformation. Kitchen and bathroom cabinets can not be made of fibreboard, but should use three plywood, because the water absorption of fiberboard is strong, it will swell and damage when it meets water. Check the surface, but also open the door, drawer door to see inside, the internal material is not decadent, you can use a fingernail pinch a pinch, pinch it, it shows that the internal decay. After the doors opened with a nose to smell, if red nose, eyes, tears, that because the formaldehyde content is too high, will be harmful to the human body. 3 should pay attention to the structure of the furniture is solid, a junction is tight. Small pieces of furniture in the cement floor mop in the selection, fall gently, crisp sound, explain quality is better; if the sound hoarse, have split Li Zhen pull murmur, that is not combined with tight mortise structure is not strong. The desk and table can be shaken and shaken by hand to see if it is steady. The sofa can sit, shake with, if not active, not weak, no sound, explain mortise structure, more reliable, if sit easily rattled loud, shake shake, a nail is live, it does not take a long time. Table, table, chair legs should have four triangular clip fixation, if not, the time long may fall apart.
Attention should be paid to the moisture content of wood. Because of the high moisture content, wood easily warp and deform. The moisture content of furniture should not exceed 12%, the general consumers to buy, no test instrument, can adopt touch method, with his hand to the bottom surface of the furniture or unpainted place, if you feel dry, so the moisture content of at least 50% or more, can not be used. Another way is to have painted wood. Sprinkle a little water, if the slow down or not down, indicating high moisture content. Selection of artificial board deformation, side expansion, intermediate concave and convex phenomenon, indicating that the board water absorption rate is too high.
Pay attention to the furniture edge, edge is smooth and tight. Sealing edge is uneven, explain inside material wet, a few days edge will be dropped. Edge should also be rounded, can not straight edge right angle. Use wood seal edge to damp or crack. Three plywood package of furniture, bags strip is nail, and should pay attention to nail eye is flat, nail eye and other place is the same color. Usually nail eyes are sealed with putty, and should pay attention to whether the putty drum up, such as drum up on it can not, and slowly putty will fall out from inside.
For veneer furniture, whether with wood veneer, PVC paint or stick the paper, should pay attention to whether the paste was smooth, without bulge, blistering, patchwork lax phenomenon. Check the directed light, red light does not see it. Ash wood veneer furniture is easy to be damaged, with only two years in general. Wood veneer, veneer edge planing peeling than good. The method of identifying the two is to look at the pattern of the wood, the cut veneer wood texture is straight and dense, spin cut single plate pattern and sparse. Particleboard veneer furniture, some of the places to be edge, edge board will not absorb moisture, swell and damage. Generally, it is easy to raise the corners and corners of the veneer furniture. When you pick it, you can use your hands to buckle the corners. If a button comes up, it shows that there is a problem with glue.
