Where can I buy a replacement stem for a Mya Saray Large Gyro Hooka?
Whoever installed the microwave and vent are the ones liable here This is going to be below your homeowners deductible, so no real chance for a claim there.
You can always check with your homeowners insurance, but i doubt if it will be coveredMost homeowner policies have a deductible and the 350 is probably below that amount.
Homeowner's insurance does cover some types of accidents (not sure if this is one of them)Natural disasters are not the only thing covered by homeowner's insuranceHowever, homeowner's insurance has a deductible of more than $350If you have a claim for something that only costs $350, then you pay all of it and the insurance pays nothingA warranty does not cover accidentsIf you paid someone else to install the microwave and vent, and that installer accident broke something, then that installer (not your insurance) or the installer's liability insurance (not your insurance) should pay for itIf you were doing the installation yourself, you will have to pay for it yourself; no warranty or insurance will helpThe only warranty or insurance that will pay is the installer's insurance, and only if you were not the installer.
Ok I literally just fixed the valve part on my hookah, which requiored me to remove the stem tube and replace itIf you want to buy copper stem tube I would go to a specialty hardware store.and purchase 5/8 inch copper tube.if you dont want to go here.go to lowe's or home depot go to the hardware section and get the aluminum tubes they haveYou might have to sand it a bit to fit.but its aluminum and its soft so you will be ok ok if you want to remove the stem in your current hookah.take a lighter and heat around the inside of the top of the hookah ( where you actually put the hookah head piece)this will melt the solder enough to pull it apart.then do the same for the bottompull the tube outand I would sugest JB-weldthis is a great way to get a good seal and not worry about solder, solder gun.burning carpet.etcand make sure you seal the area between the pipe and the actual hookah outer casing without blocking the pipeif you have any other questions let me know.
