i would like to know exactly where i can disconnect my wire feed that goes into my door. Theres a couple places i think maybe it comes undone, but i dont want to force anything and break a connector. i need to take off my door.
It is usually best to disconnect wiring for doors inside the door. Then take the wires rubber seal out of the door so it is all together when you are ready to replace the door. It saves pulling the car apart to find the correct wiring.
the main connector is in the kick panel on the floor it should b in there somewhere or u can just undo each connector inside the door and pull them through the hole in the door with the rubber boot
in case you realize for a incontrovertible fact that that's unlocked then you particularly will ought to get interior the back of the motor vehicle and get rid of the trim panel from the hatch and look to be certain if the the linkage between the cope with and the latch mechanism has come aside. if that's the case once you examine it out, you will might desire to be certain why it got here aside. that's often because of the plastic clips that carry them mutually breaking. those clips could be bought at a Chrysler sellers areas branch for a somewhat low cost.
You need to pop off your door panel by taking out all the screws first then un- hook the snap rivots all around the edge of the door and slide it over the door handle but youll have to unplug the speaker and window switch first. After its off all you need to do is follow the wiring that goes thru the grommet in the crotch of the door where it closes near the fender and there is alot of wires so make sure you take your time and dont snap off the harness hooks because they brake easily. You'll have some that go to your speaker and some to the main door window/locks/mirrors all those. If you look at that grommet previously mentioned pull it out and you can slide all the wires thru that open hole and your done. Alot of this stuff is taped or screwed on so take your time if it doesnt go on the first pull then look at whats holding you. Hope this is what you needed and if you need more ill be happy to accept an email on this situation
