Which specification provisions on the cast-in-place brick wall, the wall should be in the bottom of the plate to strengthen the reinforcement
The wall of the board is only a board to the board, so no need to press the entire wall to be reinforced, which formed the phenomenon of reinforced under the wall. Not necessarily all of the board masonry walls need to be reinforced, it depends on the design requirements.
According to the stress analysis of the board. The main consideration in the design of the reinforcement is the surface load. If you build a wall on the board, both in the short or long direction to the board and increase the wire load, so the need to strengthen the reinforcement within the board to improve the requirements of the wall of the bending resistance.
General design people have requirements, including the addition of a few tendons, how much diameter, several iron. Norms can not be specified for how specific iron.
